Bissell crosswave pet pro wet dry vac

Test Results

Design

Vacuum Type Upright

The BISSELL CrossWave Pet Pro feels decently well-built. It's mainly made of hard plastic, although it does have an aluminum wand. It feels more robust than most other BISSELL vacuums, like the BISSELL Adapt Ion Pet, though it can sometimes creak when passing over uneven surfaces like carpeting. Thankfully, it's also quite easy to take apart and reassemble.

This vacuum's handle has a hexagonal textured surface to give you a more secure grip. Most of its controls are within easy reach, with its surface mode switch on top of the handle and a detergent trigger just underneath it.

The BISSELL CrossWave Pet Pro is reasonably easy to maintain. While there are a few parts that need periodic cleaning, they're easy to access.

• Dirt compartment: You can unlatch the dirt compartment by pressing down on the release button. You should empty it after each use by lifting the cover with the 'Floater' component, which is a safety mechanism when using the vacuum as a mop, as it stops the suction motor and produces an audible 'screech' to let you know that it's full. Also, make sure you remove any large debris stuck in the dirt compartment's strainer. You can wash the dirt compartment under water along with the 'Floater' component if there's a significant amount of dirt built up. The vacuum filter is above the dirt compartment, and you should make sure that it's put back in place before refitting the dirt compartment.
• Brushroll: The brushroll is easy to access, only requiring that you lift the clear plastic brush roll window to access it and pull it free. You should clean it regularly under water to remove any stuck-on dirt or debris. While it's advertised as being an 'Anti-Tangle' brushroll, you still might find that long hair can get wrapped around it, forcing you to use a pair of scissors to cut it away.
• Filter: You need to pull out the dirt compartment before you can access the filter, which is on top of it. The filter has an attached screen to trap any fine debris or small strands of pet hair. You should wash the filter under water after every cleaning session, and you can use mild detergent if necessary.
• Water tank: The water tank is located on the back of the vacuum body and is easy to lift free of its housing. It features two separate markings for both water and detergent levels, one for small areas and the other for large areas. First, fill it up to the desired water level, and then add the required amount of detergent for the size of the room you're planning to mop. Make sure to empty the water tank after every use.

Any parts that you wash under water should be left to dry completely before refitting them.

Bag Part Number No bag

Filter Part Number 1608684

HEPA Filter Part Number No HEPA Filter

The BISSELL CrossWave Pet Pro incurs fairly low recurring costs.

• Brushroll: No replacement interval is given by the manufacturer for the brushroll, but you can buy a replacement from BISSELL's website.
• Filter: You should replace the filter every six months. You can buy a replacement from BISSELL's website.

Note: The mopping component of the vacuum incurs separate recurring costs.

• Cleaning Solution: The frequency of buying new cleaning solution depends entirely on how frequently you mop and the size of the mopping area. You can buy 80 oz bottles on the manufacturer's website, though other bottle sizes are available.

Height 46.06" (117.0 cm)

Width 14.37" (36.5 cm)

Depth 10.04" (25.5 cm)

Cord Storing Manual

On-Board Tool Storage No

Vacuum Rack/Station Yes

The BISSELL CrossWave Pet Pro has acceptable storage capabilities. It comes with a 'Rinse and Storage Tray' that you can position it on to let it dry after mopping, and there's even a separate slot to place the brushroll.

Bagless Yes

Volume 0.12 gal (0.45 L)

Full Indicator Yes

Bag Included No Bag Needed

The BISSELL CrossWave Pet Pro has an adequately-sized dirt compartment. It has roughly the same capacity as most standard cordless stick vacuums, like the Dyson V15 Detect. There's a max fill line that lets you know when it's full when vacuuming. A separate 'Floater' component automatically shuts off the suction motor and produces a screeching noise once the dustbin is filled with water while mopping.

• BISSELL CrossWave Pet Pro
• Vacuum body
• Vacuum handle with wand
• Dirt compartment
• Water tank
• Filter with filter screen
• 2x Multi-Surface brushrolls
• Strainer
• Brushroll cover
• Various accessories
• 2x 8 oz Multi-Surface Pet with Febreze detergent bottles
• Water rinse jar
• Vacuum tray
• Brushroll holder for vacuum tray
• Manuals

Cordless No

Cord Length 25.10 ft (7.7 m)

Hose Length N/A

Minimum Wand Length 3.54 ft (1.08 m)

Maximum Wand Length 3.54 ft (1.08 m)

Total Range 28.54 ft (8.70 m)

The BISSELL CrossWave Pet Pro has a reasonably long range. You can clean most rooms without worrying about swapping outlets. Unfortunately, its wand doesn't extend or retract, so you might find it hard to find a height that suits your preferences. If you're looking for a similarly designed hybrid vacuum/mop but don't want to deal with the hassle of a power cord, you should consider the BISSELL CrossWave Cordless Max 2554.

Total Weight 11.55 lbs (5.24 kg)

Weight In Hand 3.06 lbs (1.39 kg)

Carrying handle Yes

The BISSELL CrossWave Pet Pro is decently portable. While its overall weight is considerably heavier than cordless vacuums like the BISSELL Adapt Ion Pet, it's much lighter than most conventional uprights like the Shark APEX Upright Vacuum. It feels very light and has a built-in carrying handle to make it easier to pick up and carry wherever you may need it.

Minimum Battery Life N/A

Maximum Battery Life N/A

Recharge Time N/A

Recharge Dock No

Battery Life Indicator No

Removable Batteries No

Rotating Head Yes

Power Adjustment Yes

Self-Propelled No

Headlights No

Easy On/Off Yes

Head Surface Type Adjustment Manual

This vacuum doesn't have that many quality-of-life features. There are two surface settings that you can select with a handle-mounted switch: 'Area Rug' or 'Hard Floor'. However, this setting only adjusts the amount of detergent sprayed onto the brushroll when you pull the trigger, and it doesn't adjust brushroll height or suction power.

Note: While the floorhead does have a built-in light, it only turns on to light up the brushroll after pulling the detergent release trigger. The 'Headlight' field has been set to 'No'.

Brushroll Yes

Brushroll On/Off No

Removable Brushroll Yes

Turbo Brush No

Crevice Tool No

Upholstery Tool No

Soft Bristle Brush No

Hard Bristle Brush No

Extension Wand No

Ceiling Fan Tool No

Pet Grooming Tool No

The BISSELL CrossWave Pet Pro doesn't come with attachments, though there is an additional replacement brushroll for its floorhead.

Performance

Setting Used "hard floor"

Large Debris at 0 gal (0L) 86%

Large Debris at 0.07 gal (0.25L) 86%

Large Debris at 0.2 gal (0.75L) N/A

Large Debris at 0.4 gal (1.5L) N/A

Large Debris at 0.8 gal (3L) N/A

Large Debris at 1.6 gal (6L) N/A

Small Debris at 0 gal (0L) 100%

Small Debris at 0.07 gal (0.25L) 97%

Small Debris at 0.2 gal (0.75L) N/A

Small Debris at 0.4 gal (1.5L) N/A

Small Debris at 0.8 gal (3L) N/A

Small Debris at 1.6 gal (6L) N/A

The BISSELL CrossWave Pet Pro does a great job of vacuuming debris on bare floors. It easily cleans small debris like rice and sucks up most bulky debris like cereal, though you might need to make an extra pass to clean it all.

Setting Used "area rug"

Large Debris at 0 gal (0L) 39%

Large Debris at 0.07 gal (0.25L) 33%

Large Debris at 0.2 gal (0.75L) N/A

Large Debris at 0.4 gal (1.5L) N/A

Large Debris at 0.8 gal (3L) N/A

Large Debris at 1.6 gal (6L) N/A

Small Debris at 0 gal (0L) 58%

Small Debris at 0.07 gal (0.25L) 56%

Small Debris at 0.2 gal (0.75L) N/A

Small Debris at 0.4 gal (1.5L) N/A

Small Debris at 0.8 gal (3L) N/A

Small Debris at 1.6 gal (6L) N/A

The BISSELL CrossWave Pet Pro delivers mediocre vacuuming performance on low-pile carpet. It does a decent job dealing with fine debris like baking soda but has a harder time clearing larger material like sand.

Setting Used "area rug"

Large Debris at 0 gal (0L) 45%

Large Debris at 0.07 gal (0.25L) 44%

Large Debris at 0.2 gal (0.75L) N/A

Large Debris at 0.4 gal (1.5L) N/A

Large Debris at 0.8 gal (3L) N/A

Large Debris at 1.6 gal (6L) N/A

Small Debris at 0 gal (0L) 65%

Small Debris at 0.07 gal (0.25L) 64%

Small Debris at 0.2 gal (0.75L) N/A

Small Debris at 0.4 gal (1.5L) N/A

Small Debris at 0.8 gal (3L) N/A

Small Debris at 1.6 gal (6L) N/A

The BISSELL CrossWave Pet Pro delivers satisfactory vacuuming performance on high-pile carpet. It does a good job cleaning fine debris like baking soda, but you might need to make one or two extra passes to deal with larger material like sand.

Bare Floor 95%

Low-Pile Carpet 99%

High-Pile Carpet 98%

The BISSELL CrossWave Pet Pro does a fantastic job dealing with pet hair. It easily cleans this kind of debris on bare floors as well as on low and high-pile carpet.

Maximum Suction 3.4 inH₂O (0.85 kPa)

Setting Used For Maximum "hard floor"

Normal Suction 3.4 inH₂O (0.85 kPa)

Setting Used For Normal "hard floor"

Hose Diameter N/A

The BISSELL CrossWave Pet Pro has okay real-world suction performance, though it can lose a significant degree of performance in this regard if you don't clean its filter regularly. Since there's no difference in brushroll height or suction power when swapping between the 'Hard Floor' and 'Area Rug' modes, you likely won't experience any changes in debris pickup performance depending on the mode you select.

Bare Floor 81.2 dBA

Low-Pile Carpet 79.6 dBA

The BISSELL CrossWave Pet Pro is somewhat loud. At roughly 80 dBA, you'll find it very difficult to hear anyone talking nearby or any other background noise while it's running. Since there are no power adjustment settings or attachments that would change the incoming airflow of the vacuum, you won't notice any significant differences in how loud this vacuum gets. It's worth noting that the 'Floater' component inside the dirt compartment makes a noticeable screeching noise when it fills up with water.

The BISSELL CrossWave Pet Pro has mediocre maneuverability. Its floorhead pivots, allowing you to maneuver around obstacles pretty easily. However, its bulky body gets in the way when cleaning under tables and chairs. Shag-pile carpeting is also a significant obstacle for this vacuum, as it can get stuck inside the floorhead. Thankfully, you likely won't experience this problem while vacuuming low or moderately high-pile rugs and carpets.

Sofa Pickup Post Test

You can't convert the BISSELL CrossWave Pet Pro into a handheld vacuum, so it isn't suitable for vacuuming pet hair on furniture.

Anti-Allergy Filter (HEPA) No

The BISSELL CrossWave Pet Pro seals in most fine particles, but some can still escape from its post-motor exhaust.

Wood Cracks Post Test

The BISSELL CrossWave Pet Pro is unremarkable for dealing with debris in cracks. It lacks the sufficient real-world suction force to lift debris embedded in deeper crevices, but it won't have too much trouble dealing with it in shallower cracks.

Stain Pickup Post Test

The BISSELL CrossWave Pet Pro does a good job dealing with stains. Unlike shop vacuums like the RYOBI 18V One+ 3 Gal. Project Wet/Dry, it has a detergent-dispersal function for its floorhead that helps deal with stains. The manufacturer recommends using the 'Hard Floor' setting to clear stains on bare surfaces but using the 'Area Rug' mode for stubborn messes since it releases more detergent onto the brushroll. It's worth noting that this vacuum can leave behind a small amount of residue after completing a pass, though thankfully it's pretty easy to clear away. You'll probably need to make several passes to fully clean most stains, and a hand mop will likely be more efficient in cleaning stubborn stains since you can manually provide a greater degree of surface agitation.

Wet Compatible Compatible without immersion

Water Pickup Post Test

The BISSELL CrossWave Pet Pro does a great job of sucking up water. It leaves the surface slightly damp but has no trouble clearing the water as a whole.

Automation

Automatic Recharging No

Automatic Bag Emptying No

Pathing Algorithm No Pathing Algorithm

Physical Boundary Markers No

Scheduled Start Buttons No

Cycle Control Buttons No

Navigation Control Buttons No

App Name No App

iOS Availability No

Android Availability No

Software Boundary Markers (No Go Zones) No

App Scheduled Start No

App Cycle Control No

Navigation Control within App No

Differences Between Sizes And Variants

The BISSELL CrossWave Pet Pro is only available in one color scheme: 'Titanium With Grapevine Purple and Sparkle Silver'. You can buy this vacuum as part of the Performance Exclusive Bundle, which comes with an additional filter, a 32oz bottle of Multi-Surface detergent, and two additional multi-surface brushrolls. You can see the label for our model here.

Let us know in the discussions if you come across another variant.

Can the Bissell CrossWave pet be used as a dry vacuum?

Can you just vacuum with a CrossWave pet pro?

Can I use my CrossWave just as a vacuum?