Here’s a few pointers to help you determine whether you have a smoke alarm or carbon monoxide ((CO) alarm, and maybe without having to unmount it: 1) Hard-wired smoke alarms are usually found in hallways and/or bedrooms, on or near the ceiling, and they often have no visible designation on the face or it is faintly embossed in the plastic. Battery-powered smoke detectors can found installed anywhere around the home by a homeowner, including garage, kitchen, and even the attic. 2) CO alarms are currently required to be in the hallway or access area to each bedroom although, again, you might find one anywhere around the house. They are more likely to be clearly marked on the face as carbon monoxide. Where you find two detectors mounted side-by-side, one is likely to be a CO detector. Then again, sometimes one of them is a long-dead smoke detector left in place. 3) Any detector device plugged into a low wall receptacle will be carbon monoxide. They are usually a rectangular shape. 4) Most builders comply with the requirement for both a CO and smoke detector in the hallway or access room to bedrooms of new new homes, which has been enfored since 2008 in Florida, by installing a combination CO and smoke detector at the double-requirement locations. They are usually clearly marked, but can also be verified by pushing the test button and hearing both a “WARNING CARBON MONOXIDE!” and “WARNING FIRE!” voice recording on many models. 5) If still undetermined, remove the smoke detector and examine the back. On most, but not all, smoke detectors you will also an find the date of manufacture stamped in small letters. Smoke detectors older than 10-years have exceeded the manufacturer’s rated lifespan and should be replaced. 6) Never assume that the all the smoke detectors are hard-wired with a battery backup because it is a newer house. The homeowner may have replaced some or all of them with battery-powered detectors mounted over the hard-wire box. If this is a concern, remove one or two of them at random and examine the back. • • • • • • • • • • • • • • • • • • • • • • • • Here’s links to a collection of our blog posts about SAFETY: • What is the best place to install carbon monoxide alarms (CO detectors) in a house? • Why is it important to use "cabinet screws" to mount the upper cabinets in the kitchen? • Is the door between an attached garage and the house required to have a closer (self-closing device)? • Can the smoke sensors in a home security/fire alarm system replace the smoke alarms required by the building code? • Should I get a lightning rod system to protect my house?
• How do I safely remove a dead rodent (rat, mouse or squirrel) from the attic? • Does pushing the test button on a smoke alarm test the smoke sensor device inside? • What is the minimum height of a ceiling fan above the floor? • Should a smoke alarm be installed in the kitchen? • Why is a double cylinder deadbolt lock on an exterior door a safety hazard? • Why are rubber washing machine hoses a safety risk? • What can I do to avoid kitchen accidents and injuries? • Where are smoke alarms required to be located? • Are carbon monoxide alarms required to be installed in homes in Florida? • Are old vinyl tile floors dangerous?
• Do you inspect for trip hazards around the home? • When should I replace my smoke alarms? • Why is an anti-tip device now required behind the range? • What are the hazards to avoid when going into an attic? • What are the warning signs of a dangerous deck?
How long does it take for an alarm to detect carbon monoxide?The CO alarm sounds if your sensor detects a buildup of carbon monoxide in your home—usually before you start sensing symptoms. With a low CO level (50 ppm), it may take up to eight hours for the alarm to go off. Higher carbon monoxide levels (over 150 ppm) can trigger an alarm within minutes.
How can you tell if there is carbon monoxide in your house?The easiest way to see if there is carbon monoxide inside your home is with a carbon monoxide detector (which also includes an alarm). In fact, many building codes require a carbon monoxide gas detector.
|